Noises travel to our ears as distortions of the air around us. It is therefore no surprise that turbulent flow through the air, such as by landing gear, can cause quite a racket. “Landing gear, being an essential part of the plane,” remarks Fred Mendonça, a member of CD-adapco’s technical organization, “sticks out like a bluff body and violently disturbs the airflow creating noise and drag. This doesn’t greatly affect fuel consumption, but it does account for 35-40% of the noise associated with landings. Other landing configuration components like the deployed slats and flaps of the wing will account for another 35-40%.”
Having contributed 70-80% of the aircraft’s noise, it is no wonder that these areas of the plane have many aeroacoustics studies associated with them.
The noise doesn’t stop at the wing; cooling racks and internal air circulation ducts will also contribute to the racket. “A cockpit has a lot of electronics and will therefore produce a lot of heat. Air channels are needed for active cooling. Compressed air, bled into the cabin compartment to maintain cabin pressure and temperature, create noise in the delivery ducts and discharge nozzles,” explains Mendonça.
This air will pass through many passageways and ducts, each time it turns or passes through an orifice turbulent flows can be created, ultimately producing noise. “Once we simulate the airflow, we can modify the design to limit noise,” said Mendonça.
The major difference between the acoustics simulations around the plane and the simulations within the ventilation is a point of reference. Instead of creating a wind tunnel for the plane to “fly through,” you now are making a smaller wind tunnel to represent the inside of the vent. Essentially, the CFD model will be solving the same equations.
However, pilots are not the only thing associated with fatigue when vibrations are involved. Portions of the plane can experience structural fatigue due to aerodynamic flow. “Any vibrations will cause fatigue stress,” said Mendonça. “But if resonance modes are excited then you have more of an issue like possible component fatigue failure.
I’m not sure DaVinci knew how noisy his dream of flight might be – but I’m sure he’d be proud of modern industry for using simulation to ease the natural trial-and-error of the scientific process.
Source: Fred Mendonça, CD-adapco
Images from Tabesh et al. “Numerical Investigation of 1/3- and Full-Scale
Partially-Dressed Small Business Jet Landing Gears”, AIAA-2012-2236